Festo presents the Optimised Motion Series, a low cost system with optimised performance.
The Optimised Motion Series is a package that makes positioning easier than before, and significantly less expensive than conventional electric positioning systems. The electric cylinder EPCO with stepper motor EMMS-ST is as simple as a pneumatic cylinder but offers the advantages of electric drives and motor controller CMMO-ST in the ServoLite mode.
All three sizes with permanently mounted, ideally matched motor, linear drive with ball screw and non-rotating piston rods with plain bearing guide are fully assembled.
End-position cushioning reduces noise upon entering the end-positions. Easy cleaning is enabled thanks to CleanLook while a long service life is assured with a running performance of 10,000km.
The CMMO-ST is a complete, closed-loop servo-controller for stepper motors with minimal heat generation, monitored safe positions and a smooth-running motor.
Optimised Motion Series with EPCO
The Optimised Motion Series allows easy configuration with the cylinder EPCO including motor, pre-assembled cables suitable for use with energy chains and stepper motor controller CMMO-ST.
The Optimised Motion Series can be quickly commissioned via web server/browser while simple selection is enabled with Positioning Drives sizing software.